TMPGENC Fehler
Hallo
Seit Kurzem hab ich in TMPGENC beim Starten des Programmes eine Fehlermeldung "interconnect=0" Hat jemand dazu eine Lösung? Bs ist Winxp pro. Es hat bisher alles immer ohne Problem geklappt, habe auch schon ältere Versionen installiert, überall das gleiche Problem. Vielleicht hat jemand einen Tip, wie man das lösen könnte, ohne gleich eine Neuinstallation von Win vorzunehmen. Danke schonmal Grüsse |
Re: TMPGENC Fehler
aus einem andern forum
ist in englisch..leider kann ich net so gut englisch hoffe es ist jem da der ist dir übersetzen kann..wenn du auch kein englisch kannst...hehe zitat: Hmm, never had that one. Did you try and go into Environmental settings and moving the directshow up the list to the top? Put VFW second on the list. Also make sure you have a later version of DirectX installed, 7.1 should work but 8.1 definitely works. 9.1b sucks, steer clear, buggy. If this doesn't work maybe you should try uninstalling, restart system, reinstall, restart system. If that doesn't work you could have another program on your maching causing a conflict (typical problem). It's a pain in the butt figuring out what program or component is causing problems and sometimes a full clean Windows Install has to be done to fix it. Hope this helps. |
Hallo. Versuch mal die DirectShow Filter in den Environment Settings zu deaktivieren (Option - Environmental setting - VFAPI plug-in). Dort den Haken bei Direct Show Multimedia File Reader entfernen und TMPG neu starten...
|
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.