software for Editing SVCDs?
Hello, hello fine folks at KVCD.
Quick question, I have been using your templates, and since I own an apex 1500 after getting my mp2 and mv1 I use avi2mpeg to mux them as an SVCD. Occasionally I'll run into a movie that runs just a tad over what I can burn. The easiest way to take care of the problem would be to edit out the end credits. Problem is tmpg-enc doesn't want to allow me to edit my SVCDs. (it gives me a floating point divided by zero error). I've also tried M2-edit, but my output file actually increases in size after trimming! Usually it goes from somthing like the original 812 megs to close to a gig! Any other ideas? Thanks much. Jeremy |
Hi jezztek,
If you still have your .mp2 and .m1v, use bbMPEG --> Settings--> General Settings tab. Look near the bottom where you can set start frame, end frames and cd size. Start with frame 1 and end with frame count just before credits. Put in your CD size and run :) -black prince |
Well, it is bbMPEG --> Start Encoding --> Settings--> General Settings tab
And you can specify the Start second, End second or Max size. :lol: Slow down with the beer, blackprince! :wink: |
Silly me, dunno why I didn't think of that...
I was planning on going through the mux as vcd, edit in tmpg-enc, de-mux, then remux as SVCD. Your way, is certainly much easier. =) Thanks both. |
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.