KVCD: Low Luma, Flashing Blocks?

PyRoMaNiA · #1 03-06-2003, 02:38 PM

I've seen this question asked quite a lot, but haven't ever seen a way to get rid of it. Even when encoding at a high CQ (around 80) using GoldDust() and Convolution3D(preset="movieLQ") i still seem to get these flashing blocks on dark surfaces, they're very irritating

...

They are in the source (which just happens to be DivX

) but not nearly as noticeable. Is there anything i can do to get rid of them??

CheronAph · #2 03-10-2003, 02:15 AM

I have the same problem

kwag · #3 03-10-2003, 03:38 AM

Quote:

Originally Posted by PyRoMaNiA

They are in the source (which just happens to be DivX

) but not nearly as noticeable. Is there anything i can do to get rid of them??

Short answer: no

If they are in the source, they will be in the destination. Remember: Trash in, trash out

-kwag

PyRoMaNiA · #4 03-10-2003, 02:03 PM

Oh...ok.

It's just that the source isn't exactly trash, its very good apart from those blocks so I thought maybe there was a way to remove them. I suppose can put up with them.

CheronAph · #5 03-10-2003, 02:35 PM

Look at this thread, it may be useful, http://www.kvcd.net/forum/viewtopic.php?t=3186

kwag · #6 03-10-2003, 09:42 PM

Quote:

Originally Posted by PyRoMaNiA

Oh...ok.

It's just that the source isn't exactly trash

I was refering to the blocks, not your movie

I should have said: Blocks in, blocks out

-kwag

logan555 · #7 03-13-2003, 05:04 AM

I have resident evil in divx format! Whan I look at it in mplayer2 it looks perfect no macroblock.
When I make the avs and look at preview in tmpgenc all the change between colors on large surface ( a dress , a wall ) are full of block.
If I make a part of the clip is like the preview!
Any suggestion?
Is something wrang whit the avs or divx configuration ?