The New OLD CQMatic problem - Final CQ value is 89.77
First please do not reply by telling me that-----
>There are a lot of threads on this problem. Do you read the forum sometimes ? ----------------------------------------------- Q: CQMatic calls flasingly TMPGEnc in a loop flashes on the screen, it says Final CQ value is 89.77 in less than one min. I have followed this "Final CQ value is 89.77 " problem for a long time and have done all the suggestions including: 1) Shorten the path extremely to e.g. L:\ 2) check "start frame sets to 0, and end frame to -1" by NOT selecting the SOURCE RANGE 3) Even not use any filters. But all failed to get the CQMatic prediction work for me. I just wonder if KWAG can do something in CQMatic to avoid this OLD problem? |
hi,
try this rebuild the <whatever>.tpr file again with tmpgenc and set the path of tmpgenc in cqmatic again it worked for me |
Re: The New OLD CQMatic problem - Final CQ value is 89.77
Quote:
If you're just doing "NOT selecting the source range" that is not enought ! You must RESET the source range to 0, -1 (and also reset the cut editing) in a first time, then uncheck the source range cheking. That's to operation that must be done ! Note: did you try to start from a brand new project in tmpgenc ? It should solve all your problems |
Thanks a lot, Guys.
That was where my problem came from. I shoud have done both. Now for the first time CQMAtic works for me. |
so what people should do to stop, final cq: 89.77 is
Code:
1. Go to TMPGenc and start a new project |
there is a 3bis:
3bis/ load the KVCD template you need. And adjust the parameters if some aren't correct (gop length for instance - it depend on the kind of movie you encode). And you do not need to reset the range editing as you are starting from a new project. So all point 4 is not really necessary. |
ok, i got it now
|
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.