when I go to the webpage where you get the templates for TMPGEnc and it says "right click" and "save as" I dont' get a "save as" all I get is "save target as" and that doesn't work and therefore does anyone have any ideas how I can get these templates to work????


thanks...

hi dionysus,wellcome,

use "save target as" ,works!
i do it now for test and it's ok.

really well maybe I'll go try it again and see if I can get it to work this time... when I went into TMPG to look for them, they were there but when I went to try and load them into the settings for the templete etc they didn't show up unless I change the files to .all file names....

thanks again... I'll post if I have any more problems and hopefully give you some better detail



well shortly after I and tried it again and realised that when I saved them they were saving as .txt files instead of the of .mcf or whatever they are so I just went and "renamed" them and now they work...


thanks for the inspiration


ttyl

save it as all files not .txt files.

yea that's what I have to do after though... I save it as "save target as" and then I go into the folder after and change it from the .txt to the right format and so far it's worked fine... but thanks for the heads up...


later.