Quantcast digitalFAQ.com Forums [Archives] - Search Results
Go Back    digitalFAQ.com Forums [Archives] > Search Forums
Showing results 1 to 17 of 17
Search took 0.00 seconds.
Search: Posts Made By: theskid
Forum: Video Encoding and Conversion 09-06-2002, 11:54 AM
Replies: 0
Views: 815
Posted By theskid
TMPGEnc: Video jerking, seems to be frames missing?

getting a few divx avi's now if i load it in tmpgenc encode to mpeg2 at 23.97(internally 29.74) fps as the same as the avi itself i get poor jerking every now and again if i encode at 29.4 fps it...
Forum: Video Encoding and Conversion 09-01-2002, 05:43 PM
Replies: 1
Views: 786
Posted By theskid
just tried to put frame rate at 30 fps as it...

just tried to put frame rate at 30 fps as it loads up in tmpgenc that what it changes too and it runs smooth as a babyies arse
so how do i get round this cause i know dvd player wont play 30 fps...
Forum: Video Encoding and Conversion 08-31-2002, 05:47 PM
Replies: 1
Views: 786
Posted By theskid
TMPGEnc: Can't get smooth picture on divx or xvid

i cant seem to get some divx.avui's to run as mpeg2 encoded with tmpgenc without jerking not all but some and they play fine as divx ect and i have put the bitrate up ect

p.s using kdvd full...
Forum: Video Encoding and Conversion 08-24-2002, 05:42 PM
Replies: 2
Views: 1,209
Posted By theskid
VirtualDub: Cannot turn audio into wav

i downloaded a xvid release of we were soldiers i can play it a ok.i can rencode the video but when i come to turning the audio into a 48khz wav (for headache) virtual dub or nano dub cant do it...
Forum: Video Encoding and Conversion 08-12-2002, 12:13 PM
Replies: 0
Views: 784
Posted By theskid
tmpgenc errors when fault on divx .avi

encoded a film near the end theres a typical block attack u usually get on dvd when a scratch on disk you know what i mean .well the .avi continues to run through it .its only for a second or 2 but...
Forum: Video Encoding and Conversion 08-03-2002, 07:01 AM
Replies: 1
Views: 906
Posted By theskid
Encoding: Video length vs audio length?

sorry i did not know where else to post this thread
which are good programs for telling you how long a video stream is m2v or mpg2 by milliseconds and seconds (a precise reading)
and audio streams...
Forum: Audio Conversion 08-01-2002, 07:00 AM
Replies: 3
Views: 1,245
Posted By theskid
but im doing a dvd its got to be 48000 khz or its...

but im doing a dvd its got to be 48000 khz or its not dvd complaint?
Forum: Audio Conversion 07-31-2002, 02:51 PM
Replies: 3
Views: 1,245
Posted By theskid
audio sync after headache

encoded film via tmpgenc actually did audio aswell
ok
wanted to try headaches audio so i multiplexed
ripped audio to wav with virtual dub from divx encoded with headache de-multiplexed the new mp2...
Forum: Video Encoding and Conversion 07-29-2002, 11:52 AM
Replies: 5
Views: 1,086
Posted By theskid
sorry m8 mistake im doing mpeg2 therefore not...

sorry m8 mistake im doing mpeg2 therefore not using kvcd template but the kdvd template the full ntsc one (newest one out)and i get jerkyness on pc not just dvd players which are pioneer 717 and...
Forum: Video Encoding and Conversion 07-28-2002, 06:34 PM
Replies: 5
Views: 1,086
Posted By theskid
sorry source is DIVX ntsc 23.97 fps im using...

sorry
source is DIVX ntsc 23.97 fps
im using kdvd full template the one were the p picture in GOP settings is way over 5000

thanks
Forum: Video Encoding and Conversion 07-28-2002, 01:47 PM
Replies: 5
Views: 1,086
Posted By theskid
Jerky video with kdvd template?

is it not the right template to use to do a kvcd template from a divx i always get the jerky video
Forum: Players, DVRs, Media Centers 07-28-2002, 05:49 AM
Replies: 0
Views: 825
Posted By theskid
mustek v562 a real beauty

this player is the best investment i ever made remote hackable macrovision can be turned off
plays the lot vcd,svcd,mp3,dvd,dvd-r,dvd-rw
and wat iread in other forums xvcd,cdvd,dvd+r,dvd+rw

and...
Forum: Authoring VCD, DVD, Blu-ray 07-27-2002, 11:06 AM
Replies: 0
Views: 717
Posted By theskid
KVCD: Spruceup authoring problem

encoded with kdvd full ntsc via tmpgenc
mpeg file ok
spruce up loads it ok
but when i come to creating a title set (video ts folder as ripped)
i get a error at 99%
error reading video input...
Forum: Video Encoding and Conversion 07-26-2002, 06:40 AM
Replies: 0
Views: 762
Posted By theskid
Kdvd full template problem?

i encoded a divx 2:35:1 i wanted to keep the aspect ratio same as so i altered the set 16:9 to 1:1 (VGA)
im having problems with the result
its very jerky doesn't run smooth the film as the...
Forum: Video Encoding and Conversion 07-25-2002, 05:37 PM
Replies: 4
Views: 846
Posted By theskid
just ran divfix on the divx file i use toolame...

just ran divfix on the divx file i use toolame with tmpgenc what i do is extract the audio to wav uncompressed (pcm) with virtual dub then let toolame encode via tmpgenc is that ok to use this way...
Forum: Video Encoding and Conversion 07-25-2002, 06:57 AM
Replies: 4
Views: 846
Posted By theskid
managed to finish this time put some more...

managed to finish this time put some more settings up to 1 ect in enviroment settings only problem picture is still jerky
here are the divx file info
codec divx 4 low motion
fps 23,976
resolution...
Forum: Video Encoding and Conversion 07-25-2002, 06:47 AM
Replies: 4
Views: 846
Posted By theskid
tmpgenc hanging problem at 100%

trying to decode a divx .avi NTSC with tmpgenc tried with normal dvd ntsc template and the kdvd dvd full template hangs at 100% each time i cancel it play the movie and its jerky as hell what i need...
Showing results 1 to 17 of 17

 

 
All times are GMT -5. The time now is 03:42 PM  —  vBulletin © Jelsoft Enterprises Ltd