Go Back    Forum > Search Forums
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Search: Posts Made By: Koen
Forum: Video Hardware Repair 04-05-2021, 05:00 PM
Replies: 23
Views: 1,289
Posted By timtape
It's good to refer to the audio examples...

It's good to refer to the audio examples provided. I'm assuming this is a linear audio track. Tape dropouts are short, momentary drops in level, especially noticeable in the treble. Dirt on the tape...
Forum: Video Hardware Repair 04-05-2021, 12:38 PM
Replies: 23
Views: 1,289
Posted By lordsmurf
gain = input volume = output Both are...

gain = input
volume = output
Both are pressure, loudness.

levels = affects loudness (gain/volume), but is neither.
And as an example, a 50% level can be louder, more volumetic, than a 70%...
Forum: Video Hardware Repair 04-05-2021, 11:53 AM
Replies: 23
Views: 1,289
Posted By latreche34
It may sound quite to your ears but that's not...

It may sound quite to your ears but that's not how gain works, Gain is not the volume it's the audio level in dB, While the Pana sample from youtube link has almost twice the audio level of the JVC,...
Forum: Video Hardware Repair 04-04-2021, 10:21 PM
Replies: 23
Views: 1,289
Posted By timtape
Yes the Pana 850 YT upload has bad dropout due to...

Yes the Pana 850 YT upload has bad dropout due to "spacing loss". As you say it's not consistent but waxes and wanes.

A dirty A/C head, worn A/C head, and especially since you say you have...
Forum: Video Hardware Repair 04-04-2021, 07:31 PM
Replies: 23
Views: 1,289
Posted By latreche34
I hope you didn't screw up the JVC one too, The...

I hope you didn't screw up the JVC one too, The JVC video and audio is way better, why bother with the Panasonic then? To me it sounds like the Panny audio level is clipping the capture card's audio...
Forum: Video Hardware Repair 04-04-2021, 03:55 PM
Replies: 23
Views: 1,289
Posted By latreche34
Post a sample before you start screwing the...

Post a sample before you start screwing the factory adjustment that can never be brought back without an alignment tape.
Forum: Capture, Record, Transfer 05-14-2015, 06:25 AM
Replies: 12
Views: 6,364
Posted By dpalomaki
My impression of the Black Magic Designs stuff is...

My impression of the Black Magic Designs stuff is it is potentially excellent for its price point, but the firmware and drivers tend to be buggy/tempermental when initially released and may take...
Forum: Capture, Record, Transfer 05-12-2015, 10:32 AM
Replies: 12
Views: 6,364
Posted By dpalomaki
Main stream professional gear is usually stable,...

Main stream professional gear is usually stable, but the bargain products may be problematic with many systems due to the wide variety of products in the PC world (less so in the closed world of...
Forum: Capture, Record, Transfer 05-12-2015, 09:00 AM
Replies: 12
Views: 6,364
Posted By themaster1
USB is the devil I had a few words with a dev...

USB is the devil
I had a few words with a dev regarding usb dvb-t cards he told me the drivers weren't optimized/buggy most of the time so i imagine it's the same for analog capture cards.
I always...
Forum: Capture, Record, Transfer 05-11-2015, 02:21 PM
Replies: 12
Views: 6,364
Posted By lordsmurf
The Blackmagic has too many documented issues --...

The Blackmagic has too many documented issues -- mostly unreported dropped frames with SD captures. So that's out.

The cheap capture stick may be the issue. Magix is lousy, one of the...
Forum: Capture, Record, Transfer 05-11-2015, 07:01 AM
Replies: 12
Views: 6,364
Posted By dpalomaki
The MB mentioned power issues? Check your power...

The MB mentioned power issues? Check your power supply. They do get old and die a slow and sometimes painful death. I've had more power supplies fail on me than any other component. Also check for...
Showing results 1 to 11 of 11

 

 
All times are GMT -5. The time now is 09:57 AM