JVC VCR power cord mod (with photos)
2 Attachment(s)
it has always annoyed me that my JVC decks don't have a removable power cord like my AG-1980.
the cords become a tangled mess in my storage cabinet so today i was bored and did this: Attachment 3044 Attachment 3045 http://i1210.photobucket.com/albums/...e/IMG_0810.jpg http://i1210.photobucket.com/albums/...e/IMG_0809.jpg |
Well, that's mighty nifty. :)
I have no problem admitting that I've (more than once) tripped over the VCR's tail. This is a good solution. The lid of a low-end JVC still has a dent in it where my knee landed on it. It was probably 1999 when that happened! After that incident, I was always more careful to wrap the cord in velcro or twist tie, and then go one further and tie it to that wimpy little plastic piece on the back. I like your method better than mine. |
only cost a couple bucks and was fairly easy.
another thing i like about it is i used a standard "mickey mouse" or cloverleaf" connector so i can use just about any length cord i want. so if the unit is close to the surge protector i dont have 6 feet of cord hanging around. the mickey mouse cords are polarized oriented so i make sure to match the live/neutral marks on the board connector. |
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.