say what is the speed you are getting with CCE laursen ?
i get 1.8 |
Getting off topic again here, we should probably start a new thread on this subject. But anyways, I wil check (haven't paid much attention to the framerate, just final time). Did you have a chance to do some more OC tests?
BTW. VM, the latest translation I sent you had two fuzzy entries that I forgot to accept. Could you please just 'unfuzzy' these for the next release ('subtitles' being one of the these words). /Lars |
currently its on a 5% more . 3.35Ghz my cpu temp is 43-45 degree celesius
i made 1 project and it went fine . the thing is i'm not using any special cooling except for 2 side fand on the case . |
Sorry for the delay in responding viper... hadn't had much time lately.
I'm not sure what speed you refer to stating '1.8'. I get very different results in the Speed entry on the CCE status window. Anywhere from 0.4-1.1 seems to depend on content and not so much resolution and Q-factor (both monitored with 352x288 and 720x576 res. with Q between 1 and 40). I looked into OC'ing once again, and found that I was already running at 5%. I stepped down from 10% when CCE hang arised. I can't seem to find where to control FSB as you did?!? I am also low on fans - only fans are in PSU and in front of cabinet (very hot air flow through PSU :? ) Finally, I looked for the libmmd.dll, but didn't find it anywhere on my system. I DO run HT though! (two CPU's in task manager). /Lars |
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.