only the first encode is completed and tmpgenc completely closes?
 

ok, when i use the 180 ntsc template, and start doing a batch encode, only the first encode is completed and tmpgenc completely closes, i tried the 120 min ntsc template and it worked fine, but i can never be able to do a batch encode with the 180 min template, by the way i am using tmpgenc 2.58, any help would be greatly appreciated.

Hi Narc,

The only difference from the current KVCD LBR and the 352x240 PLUS templates is that the LBRs MAX bit rate is 1,150Kbps and the 352x240 PLUS is 1,800Kbps. Other than that, both templates are identical, so I don't see how this could be a template issue. Make sure you have both current templates.

-kwag

thanks kwag, i wasn't sure where i could pinpoint the problem, but i was hoping that somebody may have run into the same problem, so that they could perhaps offer me a solution, cause it is getting annoying to load up a file everytime one finishes, rather than just throw in all the files and have them convert over a time period.