MovieStacker: want to make a kdvd with 544x576 resolution
I have a divx 608x336.
I want to make a kdvd with a frame di 544x576 using the script v4. Someone can explain to me the passages that I must make in order to have no cropping and to preview of the black bands on the left and to right of 32px(overscan=4), in how much on my television set the area of overscan is 32px, naturally using the moviestacker! thanks, by |
32 pixels is a LOT. I think you are sure about what you want..
So it's simple : First step, to be done only once : - open Moviestacker - uncheck "use gripfit" - drag all "round to" cursors on the position "16" - set the "block TV overscan" to "4" and "resize" (do not use overlap with such big oversan as overlap lost the picture by putting the black borders on it). - set the "Crop" method to "accurate". Second step, to do each time - load your source - check if the A/R for the source is well found by moviestacker, change it if it is not (note: for an avi, use 1:1). DO the same for the "PAL" setting - check the "anamorphic" box of the source if your source is anamorphic - choose your destination resolution (SVCD, VCD...). Note that 34/DVD full is 544*576 and 3/4small is 528*576. - check "anamorphic" for the destiantion if you plan to do an anamorphic KDVD (not for KVCD). Final step : - control the "Error" percentage. It must be as low as possible. IF it is too big, play a little with the rounding surcors (do not go under 8). Change also the overlap to 3 (or 2), try to use "average" as crop method. When you are satisfied, go to the "Avisynth script" tab, seslect your resizer, then cut the resize line and the addborders one and paste them at the correct place in your script. |
reply
Quote:
Quote:
Quote:
perhaps you have forgotten that I had to select also "ITU-R BT.601-4" from the moment that I cannot select more than 3 in block TV-Overscan, I have manually modified the lines that it gives to me moviestacker. moviestacker give me that: Code:
LanczosResize(496,400,0,0,608,336) Code:
LanczosResize(480,384,0,0,608,336) then I have to change the lines in : Code:
LanczosResize(480,368,0,0,608,336) in this way I have finally caught up my objective. -No crop and overscan=4. Ok, it seems that I have understand as it works. :D Thanks, again, Dialhot. p.s. I have tried two other divx that they had an inferior resolution regarding the frame that I have used (544x576) and in all the two cases I have used gripfit with overscan=4 and it works well. |
Re: reply
Quote:
Quote:
Quote:
Quote:
Quote:
Quote:
|
reply
Quote:
Quote:
a film pixel of 1,8119 (608/336=1,809) if I deselect it I have: 1,8583! Moreover i think that the aspect ratios related at the resize (calculated by moviestacker) is'nt correct. I get various values. Quote:
Quote:
Quote:
but it's strange that my Tv overscan is 4? |
Re: reply
Quote:
Quote:
|
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.