digitalFAQ.com Forum

digitalFAQ.com Forum (https://www.digitalfaq.com/forum/)
-   Restore, Filter, Improve Quality (https://www.digitalfaq.com/forum/video-restore/)
-   -   Vidicraft Detailer II instructions? Mode, VNX? (https://www.digitalfaq.com/forum/video-restore/3871-vidicraft-detailer-ii.html)

Argalby 01-28-2012 03:53 PM

Vidicraft Detailer II instructions? Mode, VNX?
 
Hi!

I just purchased a Vidicraft Detailer II. I wasn't able to find any instructions for it, and I think I have most of it figured out. But I have two questions:

1.) Using the "Mode" switch, when it's in the "mono" position, just produces a darker image, shouldn't it make the image black & white?

2.) is the "VNX" knob basically a video noise control ? It seems to work that way.

Thanks!

lordsmurf 02-01-2012 01:58 AM

I owned one of these, and probably used to know this. :(

1. I just do not recall.
2. For the VNX, yes, that is correct.

I upgraded to a SignVideo DR-1000 years and years ago, so I could have s-video.

Argalby 02-01-2012 03:21 PM

Thanks for your help. If I ever find out what the "Mono" position on the switch is supposed to do, I'll post the answer :)

CompProbSolv 04-12-2012 06:05 PM

I worked at Vidicraft back in the 80s and dealt with a lot of these. I'm afraid that my memory is a bit spotty, though. It has been a few years!

There was a "Mono" position on at least two different products that had two different uses. One opened up the bandwidth to allow the higher-resolution b/w signal through. The other killed the colorburst signal to disable the color processing circuitry on your TV. Many black-and-white broadcasts still had the colorburst signal, which would enable the color processing circuitry on your TV. This would often generate colors in the otherwise b/w image that were rather annoying.

If my memory is correct, the Detailer II Mono position just opened up the bandwidth. Evidence of this would be noticing that color signals still pass through as color and that adjusting the Sharpness or Detail controls (probably more so with the Detail control) will significantly affect the tint and saturation of colors.

I think it was the ProcAmp that had the colorburst killer as a Mono mode. Evidence of this would be that a color signal becomes a black-and-white signal in this mode.

VNX (originally called "Core") removed low-level enhancement (the "core" of the enhancing signal). The hope was that noise was at a low level relative to real detail and that by removing low-level enhancement it would not enhance the noise yet would leave enhancement of detail. Properly used, it could be very effective. It was a specific feature that separated the Vidicraft products from competitors. Keep in mind that it did NOT remove noise from the initial signal.


All times are GMT -5. The time now is 02:55 PM

Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.