AR change, cannot continue
i noticed i needed to change my aspect ratio during the prediction phase, so i stopped everything and resaved a new tmpgenc project file. the problem is when i tried to restart, i got the flickering tmpgenc.
it seemed that the source range was "locked" into the prediction video, about 1 min 20 sec of cuts, and would not default to the entire film. i tried a raw encode, and it was all there, just the source range would not register it. what i did was to rename the source file from wimbledon_vfapi... to wim.avi and then was able to restart the process. does cqmatic tpr file override the input tpr if the file name is the same? |
Re: AR change, cannot continue
Quote:
But you need to reload the tpr into cqmatic if you have changed it without closing cqmatic. But your problem is elesewhere : the range select should not be only uncheck but also RESET ! If you uncheck it in "advance" settings, this is enought for tmpgenc to encode all the movie (as you had) but the range edition is still saved in the project and this cause cqmatic to fail. |
Re: AR change, cannot continue
Quote:
i WAS trying to reset the source and then resave the project file, but the source is "locked" into the cuts and will not default. i did a test and just started the encode, and it started at the beggining, and i looked at the cut frame preview, and it starts at the beginning, but the source range starts part way through if i were to reload the same avi, it would still be same, unless i change the name, then all is good again. i did not close cqmatic, so that might have caused it. thanks |
Re: AR change, cannot continue
Quote:
|
Site design, images and content © 2002-2024 The Digital FAQ, www.digitalFAQ.com
Forum Software by vBulletin · Copyright © 2024 Jelsoft Enterprises Ltd.