When I use the option "Resample to 48khz" in HeadAC3he, I always get
the file mp2 to 44 KHz?
why?

Hmm,
I'm not an expert zagor but I think you can't upsample your audio from 44 to 48 if that's
what you're trying to do.
Try doing a search in the forum or wait for more help.
Cheers

Are you sure?
Put you the check mark near at lefth of resample to 48khz ?

@rds
I have to do a kdvd and the strem audio have to be 48Khz, but I have the wave to 44 Khz!

@prodator
yes, I always check the option "resample to 48Khz", but when I click on
button start, headAc3he deselect the option "resample to ....".

by

Don't you miss a dll (ssrc.dll) ? This dll is mandatory to do samplerate conversion.

All .dll are loaded correctly.

HeadAC3he give me:
"Loading ssrc.dll 1.01 (15.04.2002) engine 1.28...succeeded".

When i click on button start, headAC3he give me:

"SSRC deactivated"
by

If ssrc.Exe can do almost all conversion you can imagine, it's dll version, used by besweet and headache, can't handle "exotic" framerates.
I just failed with a 16Khz -> 48khz conversion !

That's perhaps what you have. What is the fps of your source ?

the framerate is ok.
it's 25.

Excuse me, I said "framerate" but I thought "samplerate" (in KHz)
Audio don't have fps !

Then I have a file wav (44.1 Khz).
I have to converter it to 48 kHz. (mp2).

Open besweet as usual. Set your options in "besweet" screen. Press 2Lame button, be sure that in "input options" don't be a mark in "sample rate" or keep mark but change value to 44.1 (try 2 ways).

Ok, now i'm using BeSweet GUI v0.6.

The option that I have set are:

from SSRC:
checked - Set samplimg Rate of Output file to 48000 Hz.
checked - Perform 2 pass Processing (Avoid Clipping).

from 2Lame:
Input Options : checked - Sample rate 44.1
Output Options:
checked - Encoding Mode - dual channel
checked - PSY Model - 2
checked - total bitrate - 128

Engine - checked - MP2ENC

Now, I would to know if I have to set other options, and if it's possible
to use the options sourround2 like in HeadAC3he.
by

To have the surround2, go in the Azid tab and select "surrond2" as output mode. Then, in besweet tab you have to check the "use mpa decoder" box.

thank you phil, very much.