Hello!

That is it. How can I create a KDVD/KVCD cce-sp template ? I have just to
transpose the KDVD matrix like this:



? No additional settings ? Besides, CCe-SP has an annoying bug: If I set a config in a template and then use it, ok no problems. BUT If I want another config, I have to set new config, close it and open again!? Is this a bug ?


thanks ^_^

sparskter

which version of cce-sp do you have ?

You have to change the GOP setting and the DC precision also. But "that's all".

hello!

CCE SP 2.70.02.01

The DC precision is 10 bits right? (in my picture it is 9 bits)

Could you tell me what and how to change in the GOP structure ? Idid not find an option to change the GOP structure.

I did not look the picture. 9 is correct.

The GOP is already correct in your picture. There is not a lot of settings you can change in CCE about GOP. All is under "Gop Sequence" in your picture, and you have only 2 settings that you can change M and N. 3 and 5 are okay.

Check also the box "Disable auto I frame insertion". And uncheck that low filter in the "Picture setting" The curve in green about must be completly flat.

Where did you find such a template ? BDVD, that is that ?
I never saw non-symetrical matrix and I'm not sure this can give correct result.

Thanks for the info! ^_^

It´s called BDVD and I found it on www.vmesquita.com/forum

But I want a KDVD template. And did not found one. So I have to create.

What about this:
By close I mean closing CCE SP! And open it again...
Is it a really bug?

You were close
http://www.vmesquita.com/en/guides.htm

The templates are for 2.66 and 2.67 but the last one can be used for 2.70 with just little things to fix (like encoding mode that appears as 2-pass even if the template tells to CCE to use OPV)

It's not a bug but more like a bad usage of the tool.

You have a template, you add a job using this template -> the job takes the template values.
You change the template -> the job is not affected.
You have to remove the job and add it again to give the new values to that job.

Note: if you just want to test new values there is no need to change the template ! Just set the settings for the current job (double click on it) and when you are happy, you save these settings as a template.