Go Back    Forum > Search Forums
Reload this Page Search Results
Ask Question Join / Register   FAQ     Today's Posts
Showing results 1 to 6 of 6
Search took 0.01 seconds. Search: Posts Made By: lovemymocha
Forum: Video Hardware Repair 12-30-2024, 02:39 PM
Replies: 11
Views: 1,254
Posted By BW37
Agree 100%. That’s the place to start.

Agree 100%. That’s the place to start.
Forum: Video Hardware Repair 12-30-2024, 01:12 PM
Replies: 11
Views: 1,254
Posted By latreche34
The OP needs to physically check the audio line...

The OP needs to physically check the audio line out of the camcorder if there is audio coming from it, without this step you are spinning in a void and your "customer's tape" will never get done.
Forum: Video Hardware Repair 12-30-2024, 11:02 AM
Replies: 11
Views: 1,254
Posted By BW37
I doubt that the issue is dirty heads. If I...

I doubt that the issue is dirty heads. If I understand the recording technology of 8 mm video, the same heads read and write both the video and audio information to the tape within each helical scan...
Forum: Video Hardware Repair 12-28-2024, 08:30 PM
Replies: 11
Views: 1,254
Posted By timtape
A cleaning tape is all the manufacturers...

A cleaning tape is all the manufacturers recommended owners use. Really you should have always one on hand. I cant recommend anything in particular because as a tech I can manual clean which is more...
Forum: Video Hardware Repair 12-28-2024, 05:30 PM
Replies: 11
Views: 1,254
Posted By aramkolt
I'd probably check that wiggling the connectors...

I'd probably check that wiggling the connectors around doesn't cause the sound to come back. Most camcorders also have a built in speaker that you can hear live audio from during playback - the...
Forum: Video Hardware Repair 12-28-2024, 02:14 AM
Replies: 11
Views: 1,254
Posted By timtape
Welcome. Have you run a quality cleaning tape in...

Welcome. Have you run a quality cleaning tape in the camcorder as per instructions?
Showing results 1 to 6 of 6

 

 
All times are GMT -5. The time now is 03:40 AM
Top of Page  -  Site Home  -  Forum Home  -  Archive  -  Forum Policies