Go Back    Forum > Search Forums
Reload this Page Search Results
Ask Question Join / Register   FAQ     Today's Posts
Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: MistertheMan
Forum: Video Hardware Repair 08-08-2021, 08:59 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
I was able to get a reading of ~40 by using the...

I was able to get a reading of ~40 by using the top pin of the STK pack and pin 1 (the far left pin) of connector 05 on power board B.
As for schematics, it looks like physical service and...
Forum: Video Hardware Repair 08-08-2021, 08:26 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
I had turned the flash off in the picture due to...

I had turned the flash off in the picture due to having flash on making the picture darker/lower quality. I shined a lamp inside for this one. I just took the multimeter and probed the pins going...
Forum: Video Hardware Repair 08-08-2021, 12:24 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
I took a picture specifically of the power supply...

I took a picture specifically of the power supply area just to give a better view.
Heat sink on the left, STK pack is attached to both the heat sink and Power Board B at the bottom of the picture....
Forum: Video Hardware Repair 08-08-2021, 12:06 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
While I dont have a oscilloscope, I do have a...

While I dont have a oscilloscope, I do have a multimeter which I was able to read ~120v coming off the 2 prongs from the plug that go into power board A (which is the one the transformer is on). Im...
Forum: Video Hardware Repair 08-08-2021, 07:08 AM
Replies: 14
Views: 2,219
Posted By MistertheMan
Would you happen to have an image of what I...

Would you happen to have an image of what I should be looking for? its not often I mess around with specific parts on a circuit board and there are a few boards close to the power supply.
Forum: Video Hardware Repair 08-07-2021, 11:20 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
The manual states that when first plugged in, the...

The manual states that when first plugged in, the display should show a blinking '12:00'. Instead it just shows '88:88' without blinking. The power on/off/timer buttons on the left is set to off,...
Forum: Video Hardware Repair 08-06-2021, 08:59 PM
Replies: 14
Views: 2,219
Posted By MistertheMan
Fisher recieves power, doesnt turn on?

I recently purchased a Fisher Studio-Standard Stereo VCR (model no. FVH-830, mostly likely manufactured in 1985), and have been going through hoops to fix every problem present. A melted drive belt...
Showing results 1 to 7 of 7

 

 
All times are GMT -5. The time now is 05:57 AM
Top of Page  -  Site Home  -  Forum Home  -  Archive  -  Forum Policies