Go Back    Forum > Search Forums
Reload this Page Search Results
Ask Question Join / Register   FAQ     Today's Posts
Page 1 of 2 1 2
Showing results 1 to 25 of 38
Search took 0.00 seconds. Search: Posts Made By: 916Area52
Forum: Video Hardware Repair 12-17-2024, 06:53 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Perhaps others here have had problems/issues...

Perhaps others here have had problems/issues w/smcelectronics.com. And should be helpful to check out the FYI that Dougmc has provided above.

Personally, my experience with...
Forum: Video Hardware Repair 12-16-2024, 09:59 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Thanks again for the critique. It gives me...

Thanks again for the critique. It gives me something more to consider in post editing. Normally I'd cut a little off the sides and bottom to address distracting artifacts, "head switching noise"...
Forum: Video Hardware Repair 12-16-2024, 06:31 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Thank you Those are interesting capture...

Thank you

Those are interesting capture comparisons, and valuable feedback. I dabbled for just a minute with DV (ADS PyroA/V link). Probably another rookie move on my behalf using the Pyro....
Forum: Video Hardware Repair 12-15-2024, 04:10 PM
Replies: 37
Views: 1,998
Posted By 916Area52
Valid observations too be sure. My...

Valid observations too be sure.

My evaluation was done with the four 7800s I have, with the same Pana. All of the 7800s returned the same or very similar statistics.

Just happen to know a...
Forum: Video Hardware Repair 12-15-2024, 08:18 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Pacino's line from The Godfather Part 3 "Just...

Pacino's line from The Godfather Part 3 "Just When I Thought I Was Out They Pull Me Back In"

With my current setup, my milage/experience with the 7800 on board TBC has been less than impressive.
...
Forum: Video Hardware Repair 12-15-2024, 07:33 AM
Replies: 37
Views: 1,998
Posted By 916Area52
If one has a Pana ES-xx in their workflow, why...

If one has a Pana ES-xx in their workflow, why would you need/require a VCR w/an on-board TBC?

Not wasting any more energy with this.
Forum: Video Hardware Repair 12-15-2024, 05:19 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Thank you :-) Relatively new to this hobby...

Thank you :-)

Relatively new to this hobby and it has been a interesting journey, always something new to learn.

@ lordsmurf…
You confuse me… I’ll admit it doesn’t take much these days.
...
Forum: Video Hardware Repair 12-14-2024, 10:28 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Following up on post #21… Purchased the 4800...

Following up on post #21…

Purchased the 4800 for parts for two of my 7800’s.

VCR #1… I had serviced for a squeaky drum. A non- 7800 drum and stator was used for a replacement. I wanted to get...
Forum: Video Hardware Repair 12-14-2024, 09:17 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Hi All, My “parts” (one JVC HR-S4800U)...

Hi All,

My “parts” (one JVC HR-S4800U) arrived yesterday. Very happy my Luck held up. Packaging was done with care, I put it through its paces and am very happy with this find.
Forum: Video Hardware Repair 12-11-2024, 06:43 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Forward-thinking is always a good thing....

Forward-thinking is always a good thing. Hopefully this purchase of the 4800 will serve my purpose for the time being, assuming it's in working order. It's been my limited experience w/eBay that when...
Forum: Video Hardware Repair 12-11-2024, 05:55 AM
Replies: 37
Views: 1,998
Posted By 916Area52
I believe the parts I require are? According to...

I believe the parts I require are? According to the service manual.
Forum: Video Hardware Repair 12-11-2024, 05:33 AM
Replies: 37
Views: 1,998
Posted By 916Area52
Hello all, As of this posting, I've pulled...

Hello all,

As of this posting, I've pulled the trigger for a "working/tested 4800" from eBay @ $124.00 delivered. We shall see how this shakes out.

Thanks to All who have takin the time to...
Forum: Video Hardware Repair 12-10-2024, 08:39 PM
Replies: 37
Views: 1,998
Posted By 916Area52
Any place to buy JVC VCR parts?

Hello,
Roy here,

Hoping you all could steer me in the right direction? Finding parts for my four JVC HR-S7800U VCRs have been increasing difficult over the years. Is there a source(s) for parts?...
Forum: Capture, Record, Transfer 09-17-2024, 11:47 AM
Replies: 12
Views: 2,511
Posted By 916Area52
Why “Beware eBay VCR seller Natob82”?

Pleased that I didn’t see this thread before reaching out to Natob82

My experience,

Recently I put a call out to have two of my JVC HR-S7800U VCR’s serviced and or repaired. The two 7800’s...
Forum: Capture, Record, Transfer 08-15-2024, 08:16 PM
Replies: 35
Views: 4,145
Posted By 916Area52
Appreciate, Post #36 is what I did. Was...

Appreciate,

Post #36 is what I did. Was hoping for a better outcome than OBS or Elgato.

Plan on redoing all of my VHS collection.

Definitely need to get better educated with the proper...
Forum: Capture, Record, Transfer 08-15-2024, 07:44 PM
Replies: 35
Views: 4,145
Posted By 916Area52
Take your time, I very much apricate :) Both...

Take your time, I very much apricate :)

Both YF and BTTF were Elgato, and my very early attempts with this endeavor.

I've attached a 007 clip that I recenly did (30min ago), using AmaRecTV and...
Forum: Capture, Record, Transfer 08-14-2024, 07:56 PM
Replies: 35
Views: 4,145
Posted By 916Area52
"lordsmurf Ah, you have some good tastes! ...

"lordsmurf
Ah, you have some good tastes!

Thank you. :)

I see some on the VHS-2 list. Let me see where I am this weekend, perhaps I can squeeze in a few test captures.

Young Frankenstein is...
Forum: Capture, Record, Transfer 08-14-2024, 12:12 PM
Replies: 35
Views: 4,145
Posted By 916Area52
Good morning/afternoon Aya_Rei, No offence...

Good morning/afternoon Aya_Rei,

No offence taken…



It is significantly more compressed. The full OBS 007.mp4 file is over 7GB, whereas the recent uploaded clip full version Elagato file...
Forum: Capture, Record, Transfer 08-14-2024, 08:47 AM
Replies: 35
Views: 4,145
Posted By 916Area52
Good morning, Thank you for the input. ...

Good morning,

Thank you for the input.

Guess I don’t have an eye for it. The clip that Aya_Rei provided and the clip that is attached looks no better or worse to me. Just saying that I can’t...
Forum: Capture, Record, Transfer 08-13-2024, 07:03 PM
Replies: 35
Views: 4,145
Posted By 916Area52
Good afternoon/evening aramkolt, Just to...

Good afternoon/evening aramkolt,

Just to follow up…

Must say that I’m very happy with the settings outlined in the link that you provided for OBS ( https://www.youtube.com/watch?v=tk-n7IlrXI4...
Forum: Capture, Record, Transfer 08-13-2024, 10:02 AM
Replies: 35
Views: 4,145
Posted By 916Area52
Good morning, I’ve read/heard that as...

Good morning,



I’ve read/heard that as well from several sources.



Would whole heartedly agree with that observation.
Forum: Capture, Record, Transfer 08-12-2024, 06:57 PM
Replies: 35
Views: 4,145
Posted By 916Area52
That was the exact capture chain I used for that...

That was the exact capture chain I used for that clip, along with a computer configured as follows…

Asus H110M-C motherboard (1151 socket)
Intel Core i5-6500 Processor
32G DDR4 2133
Kingston...
Forum: Capture, Record, Transfer 08-12-2024, 11:25 AM
Replies: 35
Views: 4,145
Posted By 916Area52
What a wealth of information, expertise and...

What a wealth of information, expertise and experiences in the feedback here.

My journey started innocent enough. Just wanted to convert the few VHS tapes and DVDs that I had to a more portable...
Forum: Capture, Record, Transfer 08-11-2024, 04:43 AM
Replies: 2
Views: 863
Posted By 916Area52
Thanks, I'll be checking into that, for sure.

Thanks, I'll be checking into that, for sure.
Forum: Capture, Record, Transfer 08-11-2024, 04:28 AM
Replies: 35
Views: 4,145
Posted By 916Area52
"latreche34... They are not TBCs in a sense that...

"latreche34... They are not TBCs in a sense that they don't have analog output". A detail I did not notice.

Thank you all for your feedback.
Showing results 1 to 25 of 38
Page 1 of 2 1 2

 

 
All times are GMT -5. The time now is 06:50 AM
Top of Page  -  Site Home  -  Forum Home  -  Archive  -  Forum Policies