|
I have a couple of Canon ZR65 miniDV camcorders that work great but they are out of alignment. Looking at the service manual, it shows a connector being made to the left side of the unit that allows putting a scope on the output. ( ZR65 waveform output.jpg).
The part it refers to ( DY9-1387-000 ) only turns up google hits where it's referred to in copies of the service manual.
Where might I find one of these? When I look at what it connects to, it's a small plastic header block ( IMG_2579.jpg - the the small white header right by L1504) that doesn't look like it lends itself to attaching an o-scope probe. Should I probe elsewhere?
Thanks for any suggestions?
|
